18|Get up to 8% off with Winner’s Circle
 4
‹ Flute
 5
‹ Flute
6
‹ Flute ›
HTM2 
CARBIDE END MILL (03-3668):
1.	5-Flute End Mill for stainless 
and high-temp alloys
2.	Centered Cutting + Variable 
Pitch + 38-Degree Helix Angle 
for heavy roughing or 
Trochoidal HSM
3.	Super-hard heat-resistant 
AlTiN Coating
HSPM2 
CARBIDE END MILL (03-3655):
1.	Highest performing 
4-Flute GP End Mill
2.	Premium Micro-Grain Carbide
3.	Multi-Helix and Variable Pitch 
geometry mitigate chatter
4.	Edge treatment Reduces Vibration
HEPM 
CARBIDE END MILL (03-3687):
1.	6-Flute End Mill for Trochoidal HSM 
in tough materials up to 40 HRC
2.	Variable Pitch + 45-Degree Helix 
Angle pulls chips away and reduces 
spindle loads
3.	Chip Splitters keep chips short & 
moving away from cut
4.	AlCrN Coating yields productive 
HSM in tougher materials
HEHM 
CARBIDE END MILL (03-2203):
1.	6-Flute End Mill for Trochoidal 
HSM with light radial cuts & 
deep axial DOC at high feeds
2.	Primarily aimed at Finishing in 
Harder Steels
3.	Equal-Pitch Geometry for 
smooth finishing passes
4.	45-Degree Helix pulls chips 
away from cutting zone while 
reducing cutting loads
Haas APX Carbide End Mills –
Engineered for greater hardness, less wear, and reduced vibration 
HaasTooling.com
MILL CUTTING TOOLS
S T E E L
Primary materials: 
Steel, Stainless, Cast Iron
Explore Now

View this content as a flipbook by clicking here.